Read these instructions before installing or using this product.
IMPORTANT! Do not cut the top track the same length as the bottom track.
NOTICE: The warranty does not apply to a product that has been modified
or altered in a manner other than as expressly permitted in the Installation
and Care Guide.
Walls must be within 3/8" (10 mm) of plumb.
Cover the drain with tape to avoid loss of small parts.
Follow the silicone sealant manufacturer's instructions for application and
curing time.
To watch this installation video online, visit www.sterlingplumbing.com.
For care and cleaning and other information; visit
www.sterlingplumbing.com/care-and-cleaning.
Read and follow all instructions.
Measure distance "A." Subtract 1/4" (6 mm) or
the width of a number 2 pencil from "A" and cut
the bottom track.
Remove the wall jambs. Drill 5/16" holes into the
walls and insert the anchors.
Required Tools
5/16" Masonry Bit for Tile
Rubber Mallet
Masking Tape
100% Silicone Sealant
32-teeth Per Inch Blade
Position the bottom track on the center of the
ledge. If needed, file the ends to match the
Reposition both wall jambs. Secure the wall
jambs with screws.
Screw Cover
Screw Cover
Parts Identifi cation
Hardware Skin Pack
Serial Number Label
Hanger Bracket
Barrel Nut
Bottom Wall
Jamb Notch
Center the bottom track on the ledge with the leg
to the outside. Tape the bottom track in place and
Measure distance "B" above the wall jambs.
Subtract 1/32" (1 mm) or the width of a saw
blade from "B." Mark and cut the top track.
Installation and Care Instructions
5400 Heavy Glass Series Sliding Shower Doors
*Need help? Contact the STERLING Customer Care Center at
For service parts information, care and cleaning, and other information,
Back Plate
Right Door
Handle Kit
Center Guide
IMPORTANT! The bottom track and wall jamb
must sit flat against the shower ledge and the
wall. If needed, trim and file the wall jamb. Use a
coin to match and to transfer the corner radius of
the shower to the wall jamb.
Place the top track over the wall jambs (either
side may face out). At each end of the top track,
insert and twist a bumper into place over the
rails. Slide the bumpers against the wall jambs.
1-800-STERLING (1-800-783-7546).
visit www.sterlingplumbing.com
**Finish/color code must be specifi ed when ordering.
Retain this document for future servicing.
Record model number from box for reference.
Model Number:______________
Screw Cover
Bottom Wall
Jamb Notch
Bottom Track
Position the wall jambs over the bottom track.
The long leg of each wall jamb faces the outside
of the shower. Plumb both wall jambs. Mark the
screw holes.
Wall Jamb – Top View
Outside of
the Shower
For both doors, slide a gasket over the top of the
glass panel and into each mounting hole. Press
the hanger bracket over the gasket and align the
hanger brackets with the mounting holes.
Bypass shower doors (36 pages)
Deck-mount bath & shower faucet (6 pages)
Bypass shower doors (36 pages)
Pivot shower door (56 pages)
Neo-angle shower door (2 pages)
Neo-angle shower door (2 pages)
Corner entry shower doors (20 pages)
Hinge shower door (44 pages)
Sliding shower and bath door (6 pages)
Self-rimming lavatory (8 pages)
Counter-mount lavatory (17 pages)
Sliding shower and bath doors (76 pages)